Rust-Oleum Galva Zinc Alu Galvanised Spray Paint Hard Hat 500ml.
This Galvanised Spray Paint from Rust-Oleum Hard Hat is a bright aesthetically pleasing cathodic protection for damaged galvanised steel. The paint contains pure zinc and aluminium as pigment and provides cathodic protection. You can use this Galva Zinc-Alu in a single coat application for low exposure environments including light industrial settings.
Make sure that all surfaces are free from dirt, grease, oil, loose rust and all other surface contaminants.
Rust-Oleum Hard Hat® was designed with industry in mind, but is more than flexible to meet the needs of DIY demands or even small jobs around the house. It is extremely versatile.
Furthermore, the industrial measure means more paint in the can, resulting in a higher coverage. Each aerosol covers 2.5m2 which equals up to twice standard aerosols. A higher film build without drips or runs, in one go. Twice the opacity of cheaper paint sprays (saving a cross layer). Normal coverage in one pass. Higher quality pigments for a longer gloss and colour retention.
In addition – Surface preparation: For best results, ensure surface is clean, dry & free from loose paint, mould & mildew, wax or oil. If wax has been used, clean the surface thoroughly with white spirit. We recommend that bare wood should be sanded before painting. Hard glossy surfaces should be abraded before painting. Cover surrounding areas to protect from spray mist.
Also – You can apply this to a multitude of other surfaces such as Metal, Wood, Plastic and even Glass with the correct preparation. The Hard Hat® Range are designed for industrial use, but can also be used in place of a ‘standard’ paint aerosol for quicker results and better coverage.
Finally, check out more points below for Rust-Oleum Black Gloss Spray Paint Industrial Hard Hat® 500ml –
- For new, bare, rust free metal or galvanised steel.
- Small areas and touch up
- Sparkling aluminium finish (80% zinc, 10% alu)
- Compromise between a protection and finish
- Resists 340 hours of salt spray testing (DIN)
- To handle after 1 hour (at 20 degrees C).
- Aerosol Coverage: 1.2m2 per Aerosol
- Touch Dry: 20 mins