Zinsser AllCoat Exterior Satin (Solvent Based) is an ultimate performance all surface paint. Designed for the long-term decoration of timber, metal, masonry, plastic, concrete, cladding and more. It forms a low maintenance water-shedding coating, re-coatable in 3 hours. Zinsser AllCoat Exterior Satin (Solvent Based) contains a biocide to protect the dried coating against fungal degradation. Designed for all exterior surfaces, it is ideal for new or previously painted wood, UPVC, galvanising, steel, aluminium, cladding, stucco, brick, stone, cured concrete, Plastisol and more. Zinsser AllCoat Exterior Satin (Solvent Based) is ideal for the redecoration and protection of all paintable, exterior surfaces; Building Cladding – e.g. Plastisol, uPVC, wood, steelwork – e.g. girders, fencing, railings and masonry surfaces.
Multi surface application
Can be applied down to 5°C
Resistant to showers after 1 hour
Excellent colour retention
Recoat time – 3 hours
15 year lifetime
Surfaces must be clean, sound and free of dirt, dust, grease, wax, loose paint or other surface contamination. Remove all existing mould and mildew before painting. To effectively remove mould and mildew, use Blackfriar Fungicidal Wash. Timber at risk from decay or insect attack should be treated with Blackfriar Exterior Wood Preservative Gold Star Clear. Very hard or glossy previously painted surfaces should be abraded and degreased. Before painting, fill all nail holes and gouges. Where necessary, spot prime knots and sap streaks with Zinsser B-I-N. Abrade & degrease unweathered plastisol & powder coatings. Allow new plaster/cement & stucco to cure 60-90 days before coating. Thoroughly degrease new galvanised steel.
WARNING! If you scrape, sand, or remove old paint, you may release lead dust. LEAD IS TOXIC. EXPOSURE TO LEAD DUST CAN CAUSE SERIOUS ILLNESS, SUCH AS BRAIN DAMAGE, ESPECIALLY IN CHILDREN. PREGNANT WOMEN SHOULD ALSO AVOID EXPOSURE.
Stir well before using. Apply when air and surface temperatures are between 5 and 32°C and humidity is less than 80%. For airless spray use tip 0.13 – 0.017 at pressure 1800 – 2400 psi. Normal application is 2 coats, however an additional coat should be applied to areas of high exposure such as sills and fascia boards.
Clean up application tools, spills and drips with white spirit. If product has dried on application tool, clean with Zinsser Brush Cleaner & Restorer. Follow manufacturer’s instructions when cleaning spray equipment. Dispose of unused or unwanted product in accordance with local laws regulating solvent-based coatings.
Touch dry: 1 hour at 20°C
Hard dry: 16 hours at 20°C
Full cure: After 7 days at 20°C
Recoat: 3 hour at 20°C
Spread Rate: 10m² per litre per coat.
Colour Range: Full Colour Range*
Gloss Level: 20%
Volume Solids: 50%
Typical film thickness per coat: 50 microns dry from 100 microns wet.
VOC: (cat. A(i), limit 500g/lt) <500g/l
Product Weight: 1.2 – 1.3Kg per litre.
Shelf life: 2 years in unopened containers
Method of Application: Brush, Roller or Spray.
Thinner: Not normally required (use white spirit for conventional spray – not more than 10%).
Cleaner: White spirits for cleaning equipment.
Note: Drying and recoat times will be extended at a lower temperature.