Osmo Anti-Slip Decking-Oil Clear Topcoat 2.5L

Osmo – Wood Meets Colour

Wood and colour from one source. You can rely on wood and finishes from Osmo thanks to in-depth expertise in both areas. They know what it comes down to in terms of wood products and finishes so you can benefit from over 100 years of our experience.

Osmo Anti-Slip Decking-Oil Clear Topcoat 2.5L

Osmo Anti Slip Decking Oil is a clear, satin topcoat for decking that has already been treated with coloured oil. Formulation to be suitable for grooved and ribbed decking and highly suitable for flat or smooth decking were an anti slip finish is required.

The microporous surface allows the wood to breathe which reduces swelling and shrinkage and the natural oils stop the surface from cracking, peeling or flaking. The natural wood character remains visible and the active ingredients protect the coating against mould, algae and fungal attack. It is highly water and dirt resistant.

Performance

• Recommended use – As a top coat for coloured Osmo Decking Oil or Natural Oil Woodstain.
• Coverage – 24m²/L with one coat.
• Recommended 1 coat (as a top coat over one coat of coloured Osmo Decking oil or Natural Oil Wood Stain only).
• Drying time – 12 Hours.

Surface Preparation

We recommend a base coat with a coloured Osmo Decking Oil, such as: Osmo Bangkirai-Oil, Larch-Oil or Douglas Fir Oil or Osmo Natural Oil Woodstain.
Before applying an Osmo coloured base coat ensure the bare wood species has been properly prepared.

Please refer to the coloured Osmo Decking Oil product for more guidance on wood species preparation. Osmo Anti-Slip Decking Oil 430 top coat acts as protection against weathering and extends the life of the coating.

Wood surface must be clean, dry and frost-free (moisture content max. 20%). Osmo Anti-Slip Decking Oil 430 is ready to use. Do not thin. Stir well using a flat stirring stick or spatula before use.
For renovation works, clean existing, intact Osmo Decking oils thoroughly with diluted Osmo Decking Cleaner. De-grey and clean already greyed or weathered wood at the same time with Osmo Wood Reviver Power-Gel and rinse well. Avoid using jet / power washers to clean as this can be detrimental to the existing coating and reduce coverage of an Osmo finish.

The finished surface is influenced by several factors, including the condition of the wood. Therefore, a trial application is always required, especially for unfamiliar surfaces.

Application

With Osmo Flat Brush, apply thinly along the wood grain and spread well. For quicker application on larger areas, we recommend our Osmo Decking Brush (150 mm) which is tailored for decking and allows you to work ergonomically. Spread well and evenly.

Allow to dry for approx. 12 hours under good ventilation.

For renovation works, one coat applied to the clean and dry surface is usually sufficient.

Care