Osmo Concrete Oil Clear Satin 2.5L

Osmo – Wood Meets Colour

Wood and colour from one source. You can rely on wood and finishes from Osmo thanks to in-depth expertise in both areas. They know what it comes down to in terms of wood products and finishes so you can benefit from over 100 years of our experience.

Osmo Concrete Oil Clear Satin 2.5L

Osmo Concrete Oil is a clear, satin impregnation oil ideal for use on nearly all types of concrete. The use of natural oils and waxes allows the product to penetrate the surface rather than creating a film. This allows the concrete to be water and dirt repellent as well as stain-resistant and reducing the dust from screed and concrete surfaces.

The microporous finish protects without cracking, peeling, or flaking.

Performance

• Recommended use – Interior concrete, stone and tiles.
• Coverage – 50m²/L with one coat.
• Recommended 2 coats.
• Drying time – 8-10 hours.

Surface Preparation

The surface must be absorbent, clean, dry and frost free. Any existing sealants must be completely removed using a suitable tile or stone sealant stripper. Please contact the manufacturer of the sealant stripper for more guidance on the most appropriate products available.

Rinse the surface well after stripping sealants. Following the stripping of sealants, the surface will need to dry for at least 7 days in well ventilated, liveable conditions. Newly laid stone or absorbent tiles will also need to dry for at least 7 days in well ventilated, liveable conditions. For concrete slabs, ensure the slab has completely dried – this could take several weeks depending on thickness.

Osmo Concrete Oil is ready to use; do not thin. A trial application is highly recommended first. Stir well.

Application

With Osmo Flat Brush, Floor Brush, Oil Finish Applicator Fleece (Hand Pad Holder) or Osmo Microfibre Roller, apply very thinly and spread well. Remove any excess wet product (pooling or streaks) with a pad or a lint-free cloth. For larger areas, remove excess oil with a rubber scraper and polish with a buffing machine (white pad).

Important: the liquid oil must be absorbed into the surface. There must not be any oil left on the surface. Allow to dry for 8-10 hours. Ventilate well while drying. Apply the second coat also very thinly. Again, remove any excess. When renovating already oiled surfaces, normally one coat on a cleaned surface is sufficient.