Osmo – Wood Meets Colour
Wood and colour from one source. You can rely on wood and finishes from Osmo thanks to in-depth expertise in both areas. They know what it comes down to in terms of wood products and finishes so you can benefit from over 100 years of our experience.
Osmo UV Protection Oil Tints Oak 2.5L
Osmo UV-Protection Oil Tints is a satin, natural oil-based finish ideal for use on all vertical wood surfaces in outdoor areas. Recommended for use on doors, windows, shutters, cladding, fences, pergolas, and summer houses. As a topcoat on already colour treated wood, Osmo UV-Protection-Oil Tints prolongs the renovation intervals significantly. As a single product application, it blocks the greying process on vertical surfaces with a UV protection factor of 12 in comparison to untreated wood when two coats are applied.
Performance
- Recommended use – Vertical wood surfaces in outdoor areas.
- Coverage – Up to 18m² per litre.
- Recommended 2 coats.
- Drying time – 12 hours.
- Re-coat time – 12 hours.
Surface Preparation
Wood surface must be clean, dry and frost-free (moisture content max. 20%). UV-Protection-Oil Tints is ready to use. Do not thin. Stir well using a flat stirring stick or spatula before use. Ideally, surfaces are sanded no finer than a P120 grit grade of sand paper. Sanding to finer grades will reduce required absorbency.
If possible, and if the wood is absorbent, please apply first coat to all sides before installation. Fresh wood containing natural wood ingredients /extractives (eg: Cedar, Teak, Mahogany or Iroko) are often less absorbent and need to weather off first before applying the product. Please refer to website ‘Suitability’ section for more details. Weathering helps ingredient rich wood become more absorbent and the wood finish adheres optimally.
For renovation works, clean old microporous stains thoroughly – if necessary sand lightly. Clean and restore already greyed or weathered wood at the same time with Osmo Wood Reviver Power-Gel. Old paints and lacquers must be completely removed. As a general rule, wear a dust mask during sanding works. To maintain absorbency, avoid sanding surfaces finer than a P120 grit. Weather ingredient rich wood after sanding.
The finished surface is influenced by several factors, including the condition of the wood. Therefore, a trial application is always required, especially for unfamiliar surfaces.
Application
Before applying the product test a small area on the surface to be treated to ensure you are happy with the finished results. Results are influenced by the condition of the wood therefore a trial application is highly recommended.
- Stir the product thoroughly.
- Apply using a brush.
- Apply thinly & evenly along the wood grain and spread well.
- Allow to dry for 12 hours under good ventilation.
- Apply a second coat as above.
Note: Always follow the manufacturer’s instructions found on the bottle.
Recoating
Simply re-apply one coat onto the clean and dry surface when signs of wear become visible.
750ml and 2.5L tins available in the following shades.
Spruce (Satin), Oak (Satin), Larch (Satin), Douglas Fir (Satin), Cedar (Satin), Natural (Satin), Light Red Cedar (Satin), Light Oak (Satin)