Product Description
COMPOXELL® is a water-based finish for decorating and restoring composite wood decks, cladding etc. Hardwearing, stain resistant and waterproofing the surface, COMPOXELL® protects composite wood from UV damage and the effects of the weather.
Properties
- Semi-transparent tinted coating.
- Stain resistant barrier (oil, grease, food, etc.).
- Waterproofs the surface.
- Easily applied.
- Quick drying.
- Low odour.
Surface Preparation
- Surfaces must be clean, dry and free of dirt, grease, oil, mildew, stains etc.
- Treat mildew with a 50/50 bleach/water solution. Scrub solution on to surface and allow to stand for 10-15 minutes rinse thoroughly. Allow to dry.
- Clean surface with COMPO-CLEAN* or suitable detergent.
- After cleaning allow wood to thoroughly dry or until it has reached a moisture content of 18% or less before applying the finish.
Application
Use as is. Do not dilute.
- Stir product thoroughly before and periodically during application.
- Apply a single, even coat of COMPOXELL® to the entire length or piece of wood, stopping at any natural breaks to avoid lapping.
- Allow to dry.
- On very old, damaged and porous surfaces apply a 2nd coat.
- Where one coat is sufficient but a greater sheen level and/or greater durability is desired a 2nd coat may be applied.
- After spray application always back-brush or back-roll to improve penetration and uniformity of coverage.
Technical Data
- Finish: Satin
- Vehicle Type: Special water-based binder
- Solvent Type: Water
- Specific Gravity at 20°C (68°F): 1.02 ±0.02
- Viscosity at 20ºC (68°F): Brookfield around 600 cps Cone-plane 19.5-21.5 cps
- Solid Content: 20% ±1%
- Flash point: Not classified as flammable.
- Shelf Life: 1 year minimum in original unopened packaging.
- Container Size: 1L, 2.5L.
- Colours: Brown, Grey
- Drying Times at 20°C (68°F) and 50% relative humidity:- Touch Dry: 1 hour- Recoat: 4 hours- Fully Dry: 12 – 24 hours depending on temperature and humidity
- Decks subject to heavy traffic should be left 24 hours before being put back in to full service.
- VOC: EU limit value for this product (cat. A/i) 140 g/L. This product contains max 100 g/L.
| Coverage: | 10-12m2 per litre |
| Tools: | Brush, roller, spray |
| Suitable for: | Exterior |
| Clean up: | Soap & water |
| Drying Time: | 12-24 hours per coat depending on temperature & humidity |
| Re-coating Time: | 4 hours |
| Suitable Surfaces: | All exterior composite woods |
Reviews
There are no reviews yet.