Check out this short video on how different Bollom Fire Resistant products can help you. Click here for more Bollom paints.
[vc_video link=”https://vimeo.com/259662100″ el_aspect=”235″ align=”center”]
Here are some quick points for Bollom Brosteel White Fire Resistant Paint For Structural Steel Ultra 60 5L –
Brosteel Ultra 60 is suitable for all types of structural steel, subject to the following minimum steel thicknesses:
- Universal Beams – flange thickness 7.6mm.
- Universal Columns – flange thickness 6.8mm.
- Hollow Sections (30 minutes) – wall thickness 4.0mm.
- Hollow Section Square & Rectangular (60 minutes) – wall thickness 6.0mm.
- Hollow Section Circular (60 minutes) – wall thickness 8.0mm.
- For thinner / lighter members please consult Tor Coatings.
This Bollom Brosteel White Fire Resistant Paint For Structural Steel Ultra 60 5L is a thin-film waterborne in-tumescent coating designed to provide 30 and 60 minutes fire resistance on standard structural steel members in internal environments. Available in 2.5, 5 and 10 litre containers.
Brosteel Ultra 60 is white, with a creamy consistency. If a finish is required, either for decoration or protection against moisture, a range of Flameguard Ultra finishes are available in ultra gloss and eggshell finishes.
Brosteel Ultra 60 is a specialist product that is easy to apply by conventional methods. All cans come complete with full instructions and coverage rates.
Steelwork to be coated with Brosteel Ultra 60 must be primed with an Anti-corrosion Primer suited to the intended environment of the building and applied to the Manufacturer’s Specification, with the exceptions that the Dry Film Thickness does not exceed 100 microns and that Thermoplastic, Bitumen or Chlorinated Rubber coatings are not used.
If the steel has been galvanised or coated with a zinc-rich primer a suitable tie-coat should be applied. Consult Tor Coatings for guidance.
Brosteel Ultra 60 can be applied by brush, roller or spray, please see data sheet for more information.
Brosteel Ultra 60 should only be applied where the surface and ambient temperature is 5°C or above, and must be maintained during the application and drying periods.
The relative humidity should be below 80% throughout the application and drying periods.
We would advise that the normal handling and ventilation precautions for solvent/waterborne paints should be observed during the application of Brosteel Ultra 60. Please refer to Health & Safety data sheets prior to commencing work.
All Data & Specification sheets can be found on the official Bollom website.
Since painting comes with certain words and phrases that you may not fully understand, we have created this Terminology Guide that can assist you.
If you have a question about this product, please get in touch and let us help you.